DAESSY Folding Mount ROP Version DFM2ROP (Frame Clamp not included)#1 (LL-MT1133) In Stock Now

The DAESSY Folding Mount – DFM2 consists of two lengths of stainless steel tube joined by a Folding Mechanism. The Horizontal Tube can be lifted through an angle of 90º and rotated down 180º to place the Horizontal Tube and Vertical Tube parallel along the side of the wheelchair. The complete mount can be removed leaving only the Frame Clamp assembly attached to the wheelchair frame; in its folded configuration the DFM2 is a very compact unit for storage or transportation. The mount is supported on the wheelchair by a Frame Clamp Assembly, which is permanently attached to either the left or right side of the wheelchair. For the standard DFM2 the Frame Clamp Assembly is composed of a Frame Clamp Inner Piece and a Frame Clamp Outer Piece. The Inner Piece is clamped to the wheelchair frame while the Outer Piece holds the vertical mount tube. An Index Clamp (IC1) secured around the lower end of the Vertical Tube engages with a positioning pin on the Frame Clamp Outer Piece to position the tube and prevent rotation. The ROP Version of the Folding Mount – DFM2ROP incorporates a Locking Mechanism at the Frame Clamp. The increased security of the connection between the Removable Frame Clamp Receiver and the Removable Outer Piece makes the Folding Mount ROP Version suitable for tilting seat systems. This mount assembly does NOT include the frame clamp (the hardware that stays permanently attached to the frame of the wheelchair). It is assumed that the borrower already has that hardware in place. **$1200.00 replacement cost.